Manual

Table Of Contents

Appendix

Appendix Appendix

California Energy Commission battery charging

testing instructions

This telephone is set up to comply with the energy-conserving standards right out of the

box. These instructions are intended for California Energy Commission (CEC) compliance

testing only. When the CEC battery charging testing mode is activated, all telephone

functions on the cordless handsets, except battery charging, will be disabled.

When first purchased and properly installed for charging (see Battery Installation and

charging on page 7), put the handset in the handset charger to charge. The CEC battery

charging testing mode is activated while charging.

If you have registered the handset to the TL86103 base, refer to the following testing

instructions.

To activate the CEC battery charging testing mode:

1. Press and hold HOLD on the telephone base for about 10 seconds in idle mode. The

telephone base shows Deregister all devices?. Then, release HOLD.

2. Quickly press HOLD again or press YES within two seconds.

When the cordless handset successfully enters the CEC battery charging testing

mode, the cordless handset screen displays To register HS, see manual.

When the cordless handset fails to enter this mode, repeat Step 1 to

Step 2 mentioned above.

To deactivate the CEC battery charging testing mode:

registration instructions.