Manual

6
Getting started
Getting started
Battery installation and charging
Install the battery, as shown on page 7. Once you have installed
the battery, the screen indicates the battery status (see the
following table). If necessary, place the cordless handset in the
telephone base to charge the battery. For best performance, keep
the cordless handset in the charger when not in use. The battery is
fully charged after 11 hours of continuous charging. See the table
in the Technical specifications section on page 33 for battery
operating times.
If the screen shows Place in charger and flashes, you need to
charge the cordless handset without interruption for at least
30 minutes to give the handset enough charge to use the
telephone for a short time. The following table summarized the
battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank
or shows Place in
charger and flashes.
The battery has no or
very little charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and
flashes.
Battery has enough
charge to be used for a
short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
NOTE: If you are on a phone call in low battery mode, you hear four short
beeps every minute.
THIS
S
I
DE UP / CE
CÔTÉ
VERS
L
E HA
UT
Ba
t
t
e
ry
P
ac
k
/
Bloc-piles
:
BT
18
33
42/
B
T
2833
42 (2.4V 400mAh Ni-MH)
WA
RN
I
NG
/
AV
ERTISSEMENT
:
DO
NOT BURN OR
PUNC
TURE BA
TTERIES.
NE
PA
S
I
NC
I
NÉRER OU PERCER
LES
PILES.
M
a
d
e in
C
hina /
F
abriqué
en ch
i
n
e
CR
1349
THIS SIDE
U
Battery Pack / Bloc-p
BT183342/BT283342 (2
W
ARN
I
NG /
AV
ERTISSE
DO NOT BURN
O
R PUNC
NE
PA
S
I
NCINÉRER OU
P
Made in China / Fabriqué
e
Step 1
Plug the battery connector
securely into the socket
inside the handset battery
compartment. Insert the
supplied battery with the
label THIS SIDE UP facing
up, as indicated.