Manualshelf

User`s manual

ManualsBrandsAT&T ManualsCordless TelephonesAT&T TL80133 Accessory Cordless Speakerphone, Black | Requires AT&T CL, CRL, CLP, TL and VTech DS, SN, or IS Series Cordless Phone System to Operate
12345678910
Getting started
3
Battery installation and charging
Install the battery as shown below.
Battery Pack :
2.4V Ni-MH
WARNING :DO NOT BURN OR
PUNCTURE BATTERIES.
THIS SIDE UP
Battery Pack :
2.4V Ni-MH
WARNING :DO NOT BURN OR
PUNCTURE BATTERIES.
THIS SIDE UP
Plug the battery connector
securely into the socket inside
the speakerphone battery
compartment, matching the
color-coded label.
1. 2.
Insert the supplied battery
with the label THIS SIDE UP
facing up as indicated.
3. Insert the tab on the bottom
of the battery compartment
cover into the battery
compartment, then press
down gently on the cover
until it snaps into place.
4. Charge the speakerphone
by placing it face upward in
the charger. The CHARGE
light on the speakerphone
turns red during charging.
CHARGE light
turns red
To replace the battery, push the tab and lift the
battery compartment cover up and off.
Lift out the old battery and disconnect it from
the speakerphone. Follow the instructions
above to install and charge the new battery.
Battery Pack :
2.4V Ni-MH
WARNING :DO NOT BURN OR
PUNCTURE BATTERIES.
THIS SIDE UP