User`s manual

Getting started

Adding and registering a speakerphone

For VTech models:

Press and hold the /FIND HANDSET button on the telephone

base for about four seconds.

The IN USE light turns on.

2. Release the button.

3. Follow Steps 3 and 4 under For AT&T models with

/HANDSET LOCATOR button on the telephone base section.

NOTES:

You can register a maximum of two TL80133 speakerphones to a cordless

telephone. The telephone base recognizes and counts a speakerphone the

same as a headset.

If the base has no prior registered speakerphone or headset, the newly-

registered speakerphone is listed as HDST/SPK or HEADSET in the intercom

menu. Otherwise, the prior registered speakerphone or headset is listed

as HDST/SPK1 or HEADSET 1, and the newly registered speakerphone or

headset is listed as HDST/SPK2 or HEADSET 2.

If the registration fails, you will hear three beeps and the voice promptthe voice prompt

"Not registered" plays once upon every key press..

As such, reset the speakerphone. Remove the battery from the speakerphone,

and insert it back into the speakerphone. Repeat the registration steps.

•