User`s manual

Appendix

Troubleshooting

The light on the headset is off while charging.

Make sure the power and line cords are plugged in correctly

and securely.

Make sure that the battery is securely installed in the

cordless headset.

Make sure the headset is sitting properly in the base to charge.

Unplug the unit’s electrical power. Wait for 15 seconds,

then plug it back in. Allow up to one minute for the cordless

headset and headset base to reset.

Clean the cordless headset and headset base charging

contacts each month using a pencil eraser or dry cloth.

Your headset or headset base might be defective. Refer to the

Limited warranty section on pages 53-55 for further instructions.

Common cure for electronic equipment.

If the unit does not seem to be responding normally, try putting

the cordless headset in its base. If it does not respond, do the

following (in the order listed):

Disconnect the power to the headset base.

Remove the cordless headset battery.

Wait a few minutes.

Connect the power to the headset base.

Install the battery again, and then place the cordless

headset into the headset base.

Wait for the cordless headset to reestablish its connection

with the headset base. Allow up to one minute for this to

take place.

•