Quick start guide TL76108 5.
Installation preparation You must install and charge the battery before using the telephone. STOP! See page 5 for easy instructions. If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack (pages 2-4). The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.
Telephone base installation (2-line jack) If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters. The telephone line cord can be plugged into LINE 1/L1+L2 or LINE 2 telephone jack in the telephone base.
Telephone base installation (1-line jack) If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters. The telephone line cord can be plugged into either LINE 1/L1+L2 or LINE 2 telephone jack.
Telephone base installation (separate line jack) If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters. Each of the telephone line cord can be plugged into LINE 1/L1+L2 or LINE 2 telephone jack.
Handset battery installation & charging 89-1324-00-00 MODEL 102 BATTERY PACK 89-1324-00-00 MODEL 102 BATTERY PACK Install the battery as shown below. After installing the battery, you can make and receive short calls, but replace the handset in the charger when the handset is not being used. For optimal performance, charge the handset battery for at least 16 hours before use. When fully charged, the handset battery provides up to approximately eight hours of talk time or four days of standby time.
Charger installation & data port use Plug the handset charger power adapter into a power outlet not controlled by a wall switch. IMPORTANT INFORMATION 1. Use only the power adapters supplied with this product or equivalent. To order a replacement power adapter, visit our website at www.telephones.att.com, or call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268. 2. These power adapters are intended to be correctly oriented in a vertical or floor mount position.
Quick reference guide - handset New message indicator Flashes when there is a new message in the answering system. Softkeys Press to select an item displayed above the key. LINE1/FLASH, LINE2/FLASH OFF/CLEAR Press LINE1/FLASH to make or answer a call on line 1. During a call, press to receive an incoming call on line 1 if you subscribe to call waiting. During a call, press to hang up. While using menus, press to cancel an operation, back up to the previous menu, or exit the menu display.
Quick reference guide - telephone base INTERCOM/TRANSFER Softkeys Press to begin an intercom conversation or to transfer a call. Press to select the item displayed just above the key. CLEAR While using menus, press to cancel an operation, back up to the previous menu, or exit the menu display. RECORD MUTE Press to record a memo, a telephone conversation, or an outgoing announcement. Press to turn off the microphone; press again to resume your conversation.
www.telephones.att.com © 2008-2009 Advanced American Telephones. All Rights Reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property licensed to Advanced American Telephones, San Antonio, TX 78219. Printed in China. Issue 3 AT&T 09/09.
