User`s manual

32
Getting started
Mailbox setup (for general mailbox)
Getting started
Mailbox setup (for general mailbox)
Notify alert
Use this feature to receive notification calls to your cell telephone or paging
device after each new telephone call message has been recorded to the
general mailbox. You can remotely access the message from a touch-tone
telephone (page 78). To receive notification calls, you must save your phone
number on the telephone base, and then set the system to call that number
after it finishes recording a message.
There is no message sent on the notification call. If the phone number called
has caller ID service, there will be an indication of the call. When you receive
a notification call, you hear silence that lasts for about 15 seconds; then the
call is ended. If no one picks up the call within three rings, the telephone
base cancels the call. The system only calls the alert number once. If your
paging device is busy, not available or off during the call, you may not
receive the notification call.
When the telephone is idle, press MENU/ENTER.
Press
or to scroll to Mailbox setup. Press MENU/ENTER.
Press
or to scroll to Notify alert. Press MENU/ENTER.
Set alert number:
Press MENU/ENTER again to select Alert call #.
Use the dial pad to enter the number (up to 32 digits) of
the telephone you want to be notified.
Press REMOVE to backspace and delete a digit.
Press
REP or SKIP to move the cursor to the left or right.
3. Press MENU/ENTER to save the setting and return to the previous menu.
There is a confirmation tone. To exit without making changes, press EXIT.
Turn alert on or off:
1. Press
or to scroll to Alert on/off. Press MENU/ENTER.
2. Press or to scroll to On or Off.
3. Press MENU/ENTER to save the setting and return to
the previous menu. There is a confirmation tone. To exit
without making changes, press EXIT.
1.
2.
3.
1.
2.
•
•
Set access code
Call screening
Notify alert
Remaining space
>
Alert call #
Alert on/off
Calling alert #
>
Alert on/off
:On
ENTER=Save