Quick start guide TL74108/TL74208/TL74308/ TL74408/TL74258/TL74358/ TL74458 5.
Installation preparation You must install and charge the handset battery before using the cordless handset. STOP! See page 3 for easy instructions. If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack (see page 2). The filter will prevent noise and caller ID problems caused by DSL interference.
Telephone base installation If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters. Install the telephone base as shown below. Telephone base installation 1.
Handset battery installation & charging MADE IN CHINA THIS SIDE UP WARNING:DO NOT BURN OR WARNING:DO NOT BURN OR PUNCTURE BATTERIES PUNCTURE MADE BATTERIES IN CHINA Battery Pack THIS SIDE UP Battery Pack BT5633/BT6823 BT5633/BT6823 3.6V 550mAh Ni-MH 3.6V 550mAh Ni-MH OR MADE IN CHINA Battery Pack WARNING:DO NOT BURN BT5633/BT6823 PUNCTURE BATTERIES 3.6V 550mAh Ni-MH WARNING:DO NOT BURN OR PUNCTURE BATTERIES MADE IN CHINA Battery Pack BT5633/BT6823 Ni-MH 3.
Charger installation 1. Plug the small end of the handset charger power adapter into the jack on the underside of the charger, then route the cord through the slot as shown. 2. Plug the handset charger power adapter into a power outlet not controlled by a wall switch. IMPORTANT INFORMATION 1. Use only the power adapters supplied with this product or equivalent. To order a replacement power adapter, visit our website at www.telephones.att.com, or call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268. 2.
Quick reference guide - handset CHARGE indicator , On when the handset is in the charger. CID Press to display the caller ID information. PHONE/FLASH Press to enter the menu. While in the menu, press to select an item or save an entry or setting. DIR REDIAL/PAUSE Press to display the directory. Press to view the redial memory. While entering numbers, press and hold to insert a dialing pause. VOLUME While on a call, press the button located on the side of the handset to adjust listening volume.
Quick reference guide - telephone base • • menus, press to cancel an operation, or exit the menu display. HANDSET LOCATOR/INTERCOM: While phone is idle, press to page handset, or initiate an intercom call. • FLASH: During a call, press to receive an incoming call if call waiting is activated. • • • CID • MENU/SELECT: CLOCK: Press to review or set the clock. ANNC.: Press to review or record the outgoing announcement; press again to quit.
www.telephones.att.com © 2008 Advanced American Telephones. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property II, L.P. d/b/a AT&T Intellectual Property licensed to Advanced American Telephones. Printed in China. Issue 4 AT&T 05/08.
