User`s manual

ManualsBrandsAT&T ManualsIP phonesSystem 75 8520T

System Defaults for Fn#411 thru 414

Table 3-2

Programming Defaults, Categories

versus Response Type (Fn# 411-414)

(--

Categorv

Entry/Exit (1)

Perimeter (2)

Interior/Follower (3)

24-Hour/Perimeter Tamper (4)

interior Tamper (5)

Day Zone (6)

Non-Alarm (7)

Audible Panic (8)

Silent Panic (9)

Fire (10)

Emergency (Medical)

(11)

Environmental (12)

Trouble Category (13)

Auxl (14)

Aux2 (15)

Keyswitch (16)

OFF

(411)

Off

Instant

Tone

Chime

Instant

instant

Instant

Off

Instant

DAY

(412)

Delay

Instant

Off

Instant

Tone

Chime

Instant

Off

Instant

NIGHT (413)

Instant

Chime

Instant

AWAY (414)

Delay

Instant

Chime

Instant

Delay

Instant

This chart shows default settings for each type of zone/classification, plus the

Listing settings (in bold)

for all UL commercial and residential listings discussed in the preceding figure.

Programming for Multiple Tamper Requirements

UL requires that telephone block monitoring initiate an alarm in the armed Levels of Protection, and

non-

alarm (Trouble) in the disarmed (OFF) Level of Protection. However, the UL bell tamper must produce an

alarm in all Levels of Protection. One panel (CCU) tamper is required on the panel door, the second is

optional; panel tampers must cause an alarm if violated in the armed mode but alarm is optional in the

unarmed mode. This may require differently programmed hardwired zones for UL tamper for telephone

block, panel, and bell.

AT&T Security System 8300 Installer’s Manual

3-25