User`s manual

820 Series: Keypads

821

Keypad Number

822 Keypad Descriptor

1= Keypad #1

etc.; maximum of 8, maximum of 5 full text

keypads. Keypads are numbered by the setting of their dip

switches. The CCU must be programmed to know which

numbers correspond to which keypads.

16chrs Describe the location of the keypad.

Programming Error Messages

The following messages may occur on your display.

ACCESS DENIED

CODE IN USE

You entered an access code, and it was incorrect.

Fn#813:

this access code is already in use as an access code or a duress

code, and cannot be used.

INVALID SENSOR NUMBER

You selected a sensor number that does not exist or is not applicable to

the action you chose to take.

NOTHING IN LIST

This is not really an error statement. It is displayed at the beginning of the

validation test

(Fn#014)

or user’s test, before any sensors have been

tested.

SYSTEM MUST BE OFF

You can only enter installer programming or the Walk Test (Verification test

from the OFF Level of Protection.

ONLY

HARDWIRED/ Fn#‘s

515, 516, and 517 should not be set to options that do not apply

ONLY WIRELESS

for the type of sensor in question (do not try to set loop speed for

SENSORS

wireless sensors, don’t set “unsupervised” for hardwired sensors).

ALARM/TROUBLE

LIST IN USE

The Alarm/Trouble List is being viewed or modified at another keypad.

AT&T Security System 8300 Installer’s Manual

3-23