User`s manual

Display
I514 PRIORITY 4 1
[SELECT] =
Enter Data
[DAY] =
Goto Enter Fn#
[SELECT] = Enter Data
[SELECT] =
Enter Data
[AWAY] = Move Down
I
512 SNSR DES 107
I
[AWAY] = Move Down
(press repeatedly until the
display shows..
71
[SELECT] =
Enter Data
[OFF] = Leave Prog'g
Comments
- It asks, “is sensor 4 a priority sensor.”
-“1” is always yes, “0” is no--for yes/no questions.
-The display verifies it is entered.
***MAKE SENSOR NUMBER 107 SUPERVISED
-The fastest way “sideways” this far (to sensor 107) is by going
to
Fn#511 and entering “107.”
-DAY takes you to “Enter Function.”
-Enter 511 so you can choose a new sensor number.
-Fn#511 invites you to select a number (but shows you that you
are still at sensor 4). Enter the sensor number where you wish to
go.
-The display verifies it is entered.
-AWAY takes you “down” to
Fn#512
-Press repeatedly until you reach the Fn# you want (517).
-Fn#517 asks if you want the (wireless) sensor to be supervised.
A “0” is no, a “1” is yes.
-The display verifies it is entered.
-Use OFF to get all of the way out of the programming mode.
-The display shows that you are at the user’s Status Menu.
c ’
Figure 3-4Moving Through the Grid (cont’d.)
. .
AT&T Security System 8300 Installer’s Manual 3-7