User guide

Park
Parked calls are like held calls except that they can be
picked up from any voice terminal. Any call, inside or
outside, can be parked on the Basic SLAC, but only one call
at a time. On the Selector Console, eight
outside calls can
be parked simultaneously; inside calls cannot be parked on
the Selector Console.
Parking a Trunk Call on the Selector Console
1.
2.
3.
Press the Group Select and DXS buttons of the Call
Park code. For example, if the number is 801, press
800 followed by the 01 button.
If the call is for someone else, dial or page that
person. Tell him/her the Call Park code on which the
call is parked.
Hang up.
Note: If the parked call is not picked up within 2
minutes, it will return to the console on a <LOOP>
button. Answer it as you would any incoming call.
The light of the Call Park DXS button flashes until the
call is answered, then goes dark.
Parking a Call at the SLAC
1. Put the call to be parked on hold.
2. Select another <LOOP> button.
3. Dial *5.
4. Listen for confirmation tone and dial tone.
Continued
33