User guide

Support Information (Contd)

Pressing the <INSPECT> button puts the display into the

Inspect mode, in which you can check the information

associated with specific buttons. Refer to the Inspect

feature for details.

The Thumb-wheel Contrast control adjacent to the screen

allows you to adjust the visibility of the display under

various lighting conditions.

The procedures in this guide include typical call information

displays.

Symbols Used in Displays

Two groups of symbols provide specific information about

incoming calls.

The following redirection symbols generally appear on the

left side of the display (Screen 1).

>—

}—

&—

A coverage call has been directed to the

console.

A call is returning to the console from a

station that is busy or that does not answer;

this symbol can also indicate a call returning

after being parked but not picked up.

The “start/split” condition has been activated

in order to extend a call; that is, the

<START> button has been pressed to split a

call (put it on temporary hold).

Continued