User`s manual

20
Getting started
Mailbox setup
When the handset is idle, press MENU/ENTER.
Press DIR or CID to scroll to Mailbox setup.
3. Press MENU/ENTER twice to select
Set access code.
4. Use the dial pad to enter a four-digit number. Press
OFF/CLEAR to backspace and delete a digit.
5. Press the Next softkey or MENU/ENTER to save
the password and to select Mailbox security.
6. Press DIR or CID to select On or Off.
7. Press MENU/ENTER to save the setting and return
to the previous menu. There is a confirmation
tone. To exit without making changes, press
OFF/CLEAR.
NOTES:
The access code must have four digits.
You will hear an error tone and the screen displays Please enter another if you
enter an access code that is already assigned.
Notify alert
Use this feature to receive notification calls to any phone number you
set (such as a cellular phone or paging device) after a new message
has been recorded to the handset mailbox. To receive notification
calls, you must save the number you wish to be notified at to the
handset, and then set the system to call this number after it finishes
recording a message.
If the number called has caller ID service, there will be an indication
of the notification call. When you receive a notification call, you
hear about 15 seconds of silence; then the call is ended. There is
no message sent and the call is only made once. If the call is not
picked up within three rings, the handset cancels the call. You may
not receive the call if the number you set is busy, not available or off
during the call.
1.
2.
•
•
Enter mailbox
access code
:0001
Back Next
Mailbox security
:Off
Back
Set access code
Notify alert
Back
Set access code