Installation guide

Application Note
b. Enter the Account N
ame. The SIP account name appears on the Dial
Plan Settings page and the Trunk Reservation page.
c. For Max Calls, enter the number of simultaneous call sessions you
purchased from Broadvox. The maximum value is 16. Setting the Max
Calls to a value that is less than the current number of Trunk
Reservations for the SIP Account will generate an error.
d. Enter the Display Name. The Display Name is the text portion of the
Caller ID that is displayed for outgoing calls.
e. Enter the User Name as provided by Broadvox. The User Name, also
known as the Account ID, is usually the company's main number.
Synapse will only accept digits for a User Name.
f. Enter the Auth User Name as provided by Broadvox. The Auth User
Name is used for authentication with the service provider and in most
cases is the same as the User Name.
g. Enter the Auth User Password as provided by Broadvox. The Auth
User Password is for authentication with the service provider. Masking
of this password is not necessary.
5. Enter the SIP Gateway Account Registration Settings.
a. Enter the number of seconds for Registration Expires. This setting
applies to dynamic registration. It is a re-registration timeout value
sent to the SIP Provider. This is usually overriden by a re-registration
interval determined by the service provider’s response. The default
setting is 3600 seconds and should only be changed on the advice of
your service provider.
6. Enter the SIP Gateway Account Server Settings.
a. Enter the SIP Server address or URL. This is the SIP Server
Hostname from your Broadvox Welcome letter.
b. If necessary, enter the SIP Server Port. Port 5060, the default
setting, is typically used for SIP transmission.
c. (Optional) Enter the Registrar Server address or URL.
d. (Optional) Enter the Registrar Server Port. If a Registrar Server
address or URL is entered in the field above, it may not be necessary
to enter a Registrar Server Port.
e. (Optional) Enter the Outbound Proxy Server address or URL.
f. (
Optional) Enter the Outbound Proxy Server Port. If an Outbound
Proxy Server address or URL is entered in the field above, it may not
be necessary to enter an Outbound Proxy Server Port.
7. Configure the Codec Configuration.
a. Enable or disable audio codecs. You can click Add > to add the
selected codec to the Enabled Codecs list, or click < Remove to add
it to the Disabled Codecs list.
8. Arrange the enabled audio codecs. Select a codec, then click  or  to change
the order. The preferred codec is G.711u; the alternate codec is G.729.
11