Instruction manual

HARDWARE DESCRIPTION
Cabinet Address Plug
An address plug is provided on the middle of the backplane of each cabinet (accessible after
removing the top rear cover) and is used to designate the cabinet number to the software. When
address plug is plugged into the designated area at CP slot 5, the cabinet is identified as Cabinet 1
at slot 6 as Cabinet 2, and at slot 7 as Cabinet 3.
*
†
Table 4-A. Total Port Circuit Packs Per System
NUMBER
PORT TOTAL PORT
OF CABINET
CIRCUIT
CIRCUIT
CABINETS NUMBER *
PACKS PACKS †
1 Cabinet 1 10 10
2 Cabinet 1
10
22
Cabinet 2 12
3 Cabinet 1
10
34
Cabinet 2
12
Cabinet 3
12
Cabinet 1 (always required)—Provides mounting for CPU/MEM, Service Circuit, and
Port CPs including Tone Detectors and Pooled Modems.
Cabinet 2 and 3 (optional)—Provides mounting for Port CPs including Tone Detectors
and Pooled Modems.
The Number of Ports per CP is specified in the CP descriptions.
4-6
November 1995