Instruction manual

User Changeable Options
Once a user has selected an option to be changed, a menu of valid settings for this option is
displayed (<Yes>, <No>, etc.).
An “X” is displayed beneath the current setting of the
options, or beneath an option that may have been changed but not yet enabled. For all
options except <Speed> (see below), settings may be selected either by moving the cursor
(using the space bar) beneath the item desired and then pressing RETURN, or by typing the
single-letter code associated with that setting.
The user is then returned to the Change
Options menu to make additional changes if required.
Changing Data Port Speed
The procedure for changing Speed settings is different from the procedure for changing the
settings of other options.
Within the Speed menu, the user may find that several values are
marked with Xs. To change a speed, move the cursor beneath each value to be changed
and type “+” to add the value or
“-” to delete it. Once the new settings have been marked,
press RETURN to translate the plus and minus signs to their proper “X” values and then
type “x” to <eXit> from the Speed menu and return to the Change Options menu. For
example:
The user enters the Speed menu and finds the following settings active:
<exit>
<low>
<300> <1200>
<2400>
<4800> <9600>
<19200>
<auto>
X
X X
X
X
To remove 9600 baud and activate autobaud, enter - under <9600> and + under <auto>, as
shown below:
<eXit>
<low>
<300>
<1200>
<2400>
<4800>
<9600> <19200>
<auto>
X X
X
X X-
+
With the cursor under any item except <eXit>, pressing RETURN provides the following:
<eXit>
<low> <300>
<1200>
<2400>
<4800>
<9600>
<19200>
<auto>
X X X X
X
Entering “x”
now allows the user to <eXit> the Speed menu and return to the Change
Options menu.
The user can make additional changes, as required.
When all of the changes have been made, the user should <eXit> the Change options
menu. The following menu is then displayed:
<Undo>
<Change options>
<View options> <Enable options>
From the above menu:
● If the user selects <Undo>, the user is returned to the Command Mode entry level
menu, deleting any option-change requests.
● If the user selects <Change options>, the Change Options menu is displayed and
the user can make additional changes as required.
2-353