Instruction manual

System Administration
A main menu gives the user ready access for these tasks:
— Adding/changing/removing voice station assignments
— Adding/removing users to and from coverage groups
— Saving translations.
A significant advantage of the AAS package is that it can be used either at the same
location or can be used remotely via a dial-up connection.
Considerations
The default system administration password (systemx5) can be changed through an
administration item.
Note, however, that a system warm start or cold start will reset the
password to this default.
Hardware Requirements
The System Administration Terminal (SAT) is a Model 703 Data Terminal (see Figure 2-56). It
is a general purpose asynchronous full duplex printing data terminal with a RS-232 interface
for data entry and retrieval.
It provides a paper record of all transactions. When located
within 50 feet of the system cabinets, it can be directly connected to channel 1 on the
ZTN130 CPU/MEM (Call Processing Unit/Memory) CP. Either on-premises or off-premises
access to the administration port is supported. The terminal operates at a speed of 1200
bps (1200 baud).
Administration port parameters are as follows:
● No parity; bit is set to zero.
● 1 start bit, 1 stop bit, and 7 data bits.
● Autobaud is invoked when carriage return is pressed (300 or 1200).
● DTR (data terminal ready) required from terminal.
● RTS (ready to send) and CTS (clear to send) not required.
● No flow control.
The Model 703 requires 115V ac 60-hertz commercial power from a 3-wire grounded outlet.
The terminal should be located on a flat surface such as a desk or table top. It is
approximately 12 inches wide, 9 inches long, and 3 inches high.
2-319