Instruction manual

Speed Dialing
Data Terminal Dialing:
System Speed Dialing codes can be entered during Data Terminal
Dialing. Personal Speed Dialing is not supported.
Display: When a call is placed by dialing a Personal Speed Dialing code, the characters
stored are displayed. If ✶ was programmed to store a pause, P is displayed in the position
of the ✶ . If ✶ was stored by programming # ✶ , only ✶ is displayed.
When a call is placed using a System Speed Dialing code, only the dialed code (#100-#189)
is displayed.
Last Number Dialed: A number called with a Speed Dialing code is saved by the Last
Number Dialed feature.
Personal Lines: The Speed Dialing feature is not accessible from Personal Lines.
Remote Access: Remote Access callers cannot use the Speed Dialing feature.
Repertory Dialing: Storing a System Speed Dialing code (#100-#189) on a REP DIAL button
saves memory space, compared to storing the whole number again on the REP DIAL button.
Speed Dialing: A Personal Speed Dialing number can include a System Speed Dialing code
only as the first four characters (but nowhere else). Personal Speed Dialing numbers cannot
include Personal Speed Dialing codes. System Speed Dialing numbers cannot include any
Speed Dialing codes.
Virtual Facilities: A Virtual Facility code may be used within Personal or System Speed
Dialing numbers. When used, it must appear at the beginning of the stored number (first four
characters).
Administration Requirements
System:
● Assign System Speed Dialing Numbers.
Voice Terminal Port:
● Allow/Deny Personal Speed Dialing on a per station basis.
2-293