Instruction manual

Speed Dialing
Speed Dialing
Description
There are two types of Speed Dialing: (1) System Speed Dialing, and
Dialing.
System Speed Dialing:
Allows the System Administrator to store up to 90 numbers (maximum
length) that are accessible by dialing 3-digit codes from any voice or data
(2) Personal Speed
of 28 characters in
terminal.
Examples of typical System Speed Dialing numbers include frequently-dialed DDD
(together with leading facility access codes for WATS, FX etc.) and account codes.
The following special characters may be used in System Speed Dialing numbers.
numbers
CHAR.
FUNCTION
✶
Produces a 1.5 second pause. (Since System 25 does not have a
Dial Tone detector, judicious use of the pause character will help to
ensure that intermediate Dial Tones are obtained before more digits
are sent.)
# ✶
Transmits an actual “ ✶ ”.
# #
Transmits an actual “ # ”.
# 1xx Represents a Virtual Facility code (where xx = 90-99). This may
appear only at the beginning of the stored number.
# 8
Marks the beginning of End-to-End Signaling. (System begins
transmitting touch-tone signals to the far end switch.)
A user cannot use a Speed Dialing number for which he/she is toll restricted, outward
restricted, or facility access restricted.
System Speed Dialing Operation: To place a call using a System Speed Dialing number, the
user goes off-hook and presses the # button on the dial pad followed by the 3 digit code
assigned to the desired number.
The system interprets the associated stored number as if it
were dialed directly. This includes analysis of the number for the various types of restriction.
This feature can also be used when entering account codes. After pressing ACCT ENTRY or
dialing “ ✶ 0 ”,
the user can enter a System Speed Dialing code. The stored number
associated with the code (the account code) will be listed in the SMDR report.
Multiline voice terminals users may assign System Speed Dialing codes to Repertory Dialing
(REP DIAL) buttons.
2-291