Instruction manual

Remote Access
Administration Requirements
System:
● Enable barrier codes (yes or no; default = yes).
● Assign DID remote access number (PDC or 0; default = 0).
● Assign system default COR for Remote Access:
— ARS Facility Restriction Level (0 to 3; default = 3).
— Toll Restriction Calls (1 to 4 or 0 for none; default = 0).
— Outward Restricted? (yes or no; default = no).
— “CO pool” dial restricted? (yes or no; default = no).
— “Other pools” dial restricted? (yes or no; default = no).
● For each barrier code defined: (Note: Set these values for the required level of security.)
— Barrier code length (5-15 digits); changing this value clears previously entered barrier
codes.
— Barrier code number (1 to 16).
— Barrier code digits (5 through 15 characters or enter 0 to remove; valid characters are 0
to 9, * and #).
— Assign barrier code’s COR:
ARS Facility Restriction Level (0 to 3; default = 3).
Toll Restriction Class (1 to 4 or 0 for none; default = 0).
Outward Restricted? (yes or no; default= no).
“CO pool” dial restricted? (yes or no; default= no).
“Other pools” dial restricted? (yes or no; default= no).
— Assign Remote Access Night Service “backup” multiline station (PDC or 0; default = 0).
— Assign RIMS barrier codes digits (5 through 15 digits [0 to 9, *, #] or 0 to remove;
default = 98765. Note: This default may require changing to satisfy security
requirements.).
Trunk Port:
● Specify Remote Access usage (no, shared, or dedicated; default = no).
SMDR type of peripheral:
● To identify CAT or non-CAT type of peripheral (yes for CAT, no for non-CAT; default= no).
November 1995
2-276a