Manualshelf

Instruction manual

ManualsBrandsAT&T ManualsComputer equipmentStarLAN 10
301302303304305306307308309310
Program
To Program a Number by Using the Code:
1.
Lift the handset and listen for dial tone.
2.
Dial #4 to enter the Program mode.
3.
Dial the number you want to program.
4.
Either:
— Press the FLEX DSS or REP DIAL button,
or
— Dial the Personal Speed Dialing code (#20-#39) to indicate where this
number should be stored.
5. Listen for confirmation tone and dial tone.
6. To program another number immediately, repeat steps 3 through 5.
7. Hang up.
To Program a Number by Using the Switch (non-SLAC terminals only):
1.
Slide the switch on the left side of the voice terminal to position P.
2. Lift the handset and listen for dial tone.
3. Dial the number you want to program.
4.
Either:
— Press the FLEX DSS or REP DIAL button,
or
— Dial the Personal Speed Dialing code (#20-#39) to indicate where this
number should be stored.
5. Listen for confirmation tone and dial tone.
6. To program another number immediately, repeat steps 3 through 5.
7.
Hang up.
8. Slide the switch back to the midpoint between P and T.
2-269