Instruction manual

Local Display
The terminal user can set any of the Local Display functions by performing the following
procedure while not active on a call:
1. If the clock/calendar screen is not already being displayed, press LOCAL (or
Time/Timer if the terminal has no LOCAL button).
The clock/calendar screen appears on the display
2. Press Set repeatedly, until the item to be changed flashes.
3.
Press Fwd or Rev to change the item’s setting.
4. To change the setting of another item, return to step 2.
5.
Press Exit.
The clock/calendar screen appears on the display.
If the alarm clock function is set, the terminal will “beep” at the selected time. This audible
alarm should not be confused with the Attendant System Alarm Indication feature, which
causes the ALARM button LED to flash when system trouble is detected.
To time an event (such as a call), the user performs the following procedure while not active
on a call:
1. If the clock/calendar screen is not already being displayed, press LOCAL (or
Time/Timer if the terminal has no LOCAL button).
The clock/calendar screen appears on the display.
2. Press Time/Timer.
The timer screen appears on the display.
3. To start the timer, press Start.
The timer resets to 00:00, then begins timing.
4. To stop the timer, press Stop.
5. To time another event, return to step 3.
6. Press Exit.
The clock/calendar screen appears on the display.
Considerations
At SLACs and logged-in DGC terminals, preference is given to queue displays over the
clock/calendar display. This condition can be overridden by pressing LOCAL, if available.
2-221