Instruction manual

FEATURES AND SERVICES
● Active Call Appearance Button
The normal call information pertaining to the call is displayed. If the display user is
excluded, EXCLUDED is displayed.
● FLEX DSS Button
The stored number and the associated name are displayed. If the button is not
programmed, FLEX DSS is displayed.
● REP DIAL Button
The digits stored on the button are displayed.
If the button is not programmed, REP
DIAL is displayed.
● FACILITY Button
The display presents information about the pooled facility in the following form.
Screen 1
XXX OF YYY BUSY
The user can return from Inspection Mode to Normal Mode
following actions:
● Press INSPECT again.
or Local Mode by any of the
● Allow timeout to occur after 15 seconds of no station activity.
● Change switchhook state; if the user goes on-hook, the terminal returns to Normal or
Local Mode; if the user goes off-hook, the terminal returns to Normal Mode.
Considerations
Activation of the Inspection feature has the following impact on terminal operation:
● Hands-Free Answer on Intercom is disabled.
● If the user is on-hook but has a call on hold, there is no effect on the call.
● If the user is off-hook and in the midst of dialing, the system disconnects the call.
● Automatic Incoming Call Identification (see “Display” feature description) is
suppressed.
● The user cannot operate feature buttons.
● The user cannot perform call-handling procedures (such as holding, transferring, or
answering a call).
2-202