Instruction manual

Inspection

Description

This feature enables the user at any voice terminal administered for the Display feature to

perform the following functions:

● View incoming call identification messages even while busy on another call.

● View information about held or bridged calls.

● Examine information stored on REP DIAL, FLEX DSS, and LAST # DIALED buttons.

● Determine the busy status of pooled trunk groups.

● Determine feature button type.

To activate this feature, the display set user must first leave Normal Mode and enter the

Inspection Mode by pressing the INSPECT button. The system presents the following prompt

on the display screen:

Screen 1

INSPECT

Then, to inspect specific information, the user presses the appropriate call appearance, loop,

or feature button.

Note:

If the user presses INSPECT immediately after dialing a call, the call may

be disconnected; a pause of several seconds is recommended.

Display Formats

When the user presses the button

information about the button.

● Assigned Feature Button

The name of the feature

DIRECTORY).

● Unassigned Feature Button

NOT ASSIGNED is displayed

● Idle Call Appearance Button

to be inspected, the INSPECT prompt is replaced by

is displayed (for example, ACCT ENTRY, SIGNAL,

The type of call appearance is displayed (for example, SYS ACCESS, PERS LINE).

2-201