Instruction manual

Data Terminal Dialing
Table 2-1.
Call Progress Messages for Data Terminal Dialing
Displayed
Message
Application
DIAL:
Placing a call
RINGING
Placing a call
BUSY
Placing a call
ANSWERED
Placing or
receiving a call
TRY AGAIN
Placing a call
INCOMING CALL-*
Receiving a call
PLEASE ANS-
Placing a call from
a voice terminal
DISCONNECTED*
Call is terminated
CONNECTED,
Call is connected
SPEED = NNNN
INCOMPATIBLE
Placing a call
FAR END
DIALING . .
Placing a call
COMPLETED
PLEASE WAIT
Placing a call
BAD NUMBER
Placing a call
NO MODEM
Placing a call
SESSION 1
Placing or
terminating a call
Meaning
Equivalent to dial tone. Enter any required
facility number followed by the dialed
number and a RETURN.
Equivalent to Ringback Tone. Called
number (far-end) is being signaled.
Provided on internal calls only.
Equivalent to busy tone. Called number is
in use, or out of service. Provided on
internal calls only.
Notifies calling and called users that call
has been answered. Provided on internal
calls only.
Equivalent to Reorder Tone. System
facilities are currently not available or
invalid number.
Equivalent to ringing.
Originating voice terminal user has
transferred call to data terminal using
Transfer to Data.
Call or call attempt is disconnected.
Notifies user that the call connection is
established and what the baud rate is.
[Provided that “Connection indication”
(Data Port Action 77) is enabled.]
Notifies user that the handshake between
data end points has failed
Indicates off-premises call is being dialed
and that dialing is completed.
Call queued.
Bad dialed number
No modem available for a call that
requires one.
Specifies the session number (1) of the
data call to the calling party
* Bell sounds when message is displayed.
2-137