Instruction manual

Coverage, Group
Administration Requirements (Standard Group Coverage)
System:
● Provide Coverage ringing on internal calls (yes or no; default = yes).
If “no”, covered calls will flash but not ring at covering stations on internal calls.
● Number of rings before Coverage ringing starts on no answer (0-31; default = 2).
The status LEDs on Group Coverage buttons at covering stations begin flashing
immediately in all cases. Ringing, in addition to flashing, is always sent on external
calls, though it may not be accepted at the covering stations.
Voice Terminal Port:
● Coverage Sender group number (1-32; default = 1).
● Provide Coverage ringing on no answer (yes or no; default = yes).
If “no”, flashing LED is the only indication received at the covering station; the calling
party always hears ringing.
● Provide Coverage ringing on busy (yes or no; default = yes).
If “no”, flashing LED is the only indication received at the covering station.
The calling party always hears ringing.
● Coverage Receiver button
— Group Number (1-32)
— Allow Ring (yes or no; default = yes).
If “no”, flashing LED is only indication received at this covering station.
Administration Requirements (DGC Group Coverage)
The parameter to assign a coverage sender group has been expanded to include DGC
groups as coverage group receivers.
DGC receiver groups are first set up as regular DGC
groups, numbered 1-32.
DGC coverage groups can then be specified by using coverage
group numbers 101-132, where coverage group 101 has DGC group 1 as its receiver group,
coverage group 102 has DGC group 2 as its receiver group, etc. No button assignments are
required.
Send ringing options (on busy, on no answer, system-wide for internal calls) have no effect
for DGC group coverage; ringing is sent for all calls that go to coverage.
The system search of group coverage sender stations has been expanded to allow the
system administrator to enter a DGC Coverage Group and list all its sender stations by PDC.
2-113