Specifications
Table Of Contents
- Table of Contents
- General Information
- Before You Start
- Installation Steps
- Connecting Speakers
- Powering Up System
- Self-Powered Controller Connections
- Controller to Generic Amplifier
- Controller to Amplified Speakers
- Controller to PagePac 20
- Controller to AmpliCenter 100
- Controller to D-Series AmpliCenter
- Troubleshooting
- Controller Specifications
- Controls and Indicators, Terminals and Connector
- Connectivity Chart
- Programming the Controller
- General Zone and Zone Group Configurations
- Output Zone/Group Configurations
- Input Zone / Group Options
- Error Tones
- Programming Quick Reference Chart
- Zone Map and Zone Configuration Tables
- Application Notes
26
Pass DTMF to the Output
NOTE: If you leave NO in
option mode, you may page
zone to zone without exiting
system. System is locked up
while you roam zone to zone.
NOTE: If you access a zone
that is enabled for passing
DTMF, you will not be able to
switch to another zone (on the
same controller) except by
hanging up and re-initializing
access to the PagePac Plus
system.
NOTE: Use ALIAS numbers, if
optioned. Otherwise, use
Physical zone/group numbers.
This zone output option enables the Touchtone telephone keypad tones
(DTMF) to be passed through the Controller and output to a second
controller or other ancillary device.
The choice is YES/NO, with the default being NO. Operating the unit in
the default mode, you may switch from zone to zone (within the same
Controller) without hanging up, simply by dialing the zone number of the
zone you wish to switch to. The DTMF tones you dial will be muted (not
sent out as audio) as soon as they are detected by the controller.
Access to the first zone will be disconnected and you will hear a
pre-announcement tone when the zone switch has been accomplished
(if pre-announcement tone has been enabled).
When you have accessed a zone with this parameter set to YES, DTMF
will be sent out as un-muted audio but the Controller will not respond to
the DTMF tones (and will not switch zones).
This YES option, with DTMF tones enabled to the output, is useful when
you have more than one Controller daisy-chained in a system. The
un-muted DTMF tone is passed through the first controller (not triggering
a zone change) to the second controller (or other ancillary device), where
it DOES activate a zone.
You will need to repeat this procedure for each output zone or zone
group that you wish to receive the DTMF tones.
1.
2.
3.
4.
Dial
9 0
to select this option.
Hear a DOUBLE beep.
Enter the zone or group zone number.
Hear a DOUBLE beep.
Enter
0
for NO (Not pass DTMF) or enter
1
for YES (Pass DTMF)
Hear TRIPLE beeps.
To verify the status of DTMF Pass for a given zone, dial
9 1
and repeat steps 2 and 3 above.
43