Specifications

1.
2.
NOTE: Use ALIAS numbers, if
optioned. Otherwise, use
Physical zone/group numbers.
3.
4.
Dial 7 6 to select this option.
Hear a DOUBLE beep.
Enter the zone or group zone number.
Hear a DOUBLE beep.
Enter 0 for NO (Not Enabled) or 1 for YES (Enabled)
Hear TRIPLE beeps.
To verify the status of Talk-Back Enable for a given zone, dial
and repeat steps 2 and 3 above.
25
Set Night Bell Enable
This is an individual zone output parameter. The choice is YES/NO with
the default being NO. With this parameter set to YES, night bell will be
sent to selected outputs whenever ring voltage is present on the night
bell input (from the PBX to the controller).
If a closure is required to trigger the night bell, then a zone will need to
be configured as an input to send night bell to designated zones when a
closure is present. This is discussed in Steps 27 and 28, Tone Selection
and Tone Routing.
You will need to repeat this procedure for each output zone that you wish
to receive the night bell signal.
1.
2.
NOTE: Use ALIAS numbers, if
optioned. Otherwise, use
Physical zone/group numbers.
3.
4.
Dial 7 8 to select this option.
Hear a DOUBLE beep.
Enter the zone or group zone number.
Hear a DOUBLE beep.
Enter 0 for NO (Not Enabled) or enter 1 for YES (Enabled)
Hear TRIPLE beeps.
To verify the status of Night Bell Enable for a given zone, dial 7 9
and repeat steps 2 and 3 above.
42