Specifications

This MUST be done before
“Zone Map Option – Assigning
ALIAS Numbers”, later in this
section.
NOTE: You may want to use a
short Connect password (2 or
3 digits only) for ease of use.
For example, 123456 is a valid
password entry. 123# is also a
valid password entry, resulting
in the password 123.
3
Define Length of ALlAS Numbers
This system option allows you to set the length (3 or 4 digits) of the
ALlAS number field. The default is 2 digits. If you wish to assign ALlAS
numbers to the paging zones, you must set the length parameter. The
ALlAS number is the dialing extension for the zone. If no ALIAS
numbers are used, the Physical Zone Code is the dialing extension for a
zone.
First access the PagePac Plus system and enter the programming mode
by pressing
✱ ✱ and then entering your Programming password (if
optioned). You may exit the programming mode by dialing
#.
1.
2.
3.
Dial 2 0 to select this option.
Hear a DOUBLE beep.
Press 3 or 4 to set length of ALIAS numbers (number of digits
dialed to reach paging zone).
Hear TRIPLE beeps.
To verify the setting, dial
2 1 and repeat step 2 above.
4 Set Connect Password
This feature will not become active until the first time you enter a
password, via the programming mode. The factory default is NO
password. The Connect password operates as a security block into the
paging system, restricting paging access to authorized users.
1.
2.
3.
Dial 3 0 to select this option.
Hear a DOUBLE beep.
Enter the Password you wish to use (up to 6 digits). If the
password has fewer than 6 digits, enter the
# to terminate the
string.
If you already have entered a password and want to remove it (to
have NO password), just enter the
# alone.
Hear TRIPLE beeps.
To verify that the new Connect password has been established, dial
3 1 and repeat step 2 above.
30