Specifications

SB67080 Expansion Module Installation and Configuration Guide Back to Contents
Configuration 24
Logging in as Administrator
To access the browser interface and log in:
1. Ensure your computer is connected to the same IP subnet as the Synapse system.
You can connect your computer to the PC port on the back of the Expansion Module
or a Deskset.
2. On the Expansion Module, press and hold the SHIFT key ( ) for five seconds. the
MENU appears.
3. On the MENU, press the key adjacent to Device Information.
4. Find the IP address on the Device Information screen.
5. Open a browser. AT&T recommends Internet Explorer 7 or higher for best
performance. (If you are using a different browser, some of the pages presented here
may look different and have different controls.) The PC must be on the same subnet
as the Expansion Module, or your network administrator must have set it up so that
devices on different subnets are able to communicate.
6. Type the Expansion Module IP Address in the address bar, and press ENTER.
The Login page opens in the browser.
Display Settings 
MENU
IP Settings 
Device Information 
Cancel
Device: EM-1
DEVICE INFORMATION
Paired with: Ext. 220
Model #: SB67080
Cancel
P1 / 2
Next
Status: Synchronized
IP: 192.168.0.110
MAC: 00:11:A0:29:8B:44
Serial #: RS50000052
Expansion Module Menu
Device Information Menu
You can also use a Gateway IP address or Deskset IP address to log in to
the WebUI. You can view the Gateway IP address on the bottom row of the
Gateway idle screen. To view the Deskset IP address, press MENU, then 4
on the Deskset.