Installation guide

Synapse Installation Guide Back to Contents
Installation 48
SB67040 Cordless Handset Installation
Charger Installation
Place the handset in the charger when not in use.
To plug the handset charger into AC power:
1. Plug the power adapter into an electrical outlet not controlled by a wall switch.
2. Plug the small end of the power adapter into the jack on the underside of the
charger.
3. Route the cord through the slot, as shown.
The SB67040 Cordless Handset requires registration to an SB67030/031
Deskset. The SB67020/025/035 Desksets do not support the SB67040 Cordless
Handset.
The SB67040 Cordless Handset is not supported when the system is in Line
Appearance mode.