Installation guide
System Configuration 91
Synapse Installation Guide
Log in as Administrator
To access the browser interface and log in:
Figure 101. 030/031 Deskset Information
Screen
Figure 102. 020 Deskset Information
Screen
Figure 103. Browser Entry
1. Ensure your computer is connected to the same IP subnet as the Synapse
system. You can connect your computer to the PC port on the back of a
Deskset.
2. On the Deskset, press MENU then 4 to display the Deskset Information
screen shown in Figure 101 or Figure 102.
3. Find the IP address on the Deskset Information screen.
4. Open a browser. AT&T recommends Internet Explorer 7 or higher for best
performance. (If you are using a different browser, some of the pages
presented here may look different and have different controls.) The PC
must be on the same subnet as the Deskset, or your network administrator
must have set it up so that devices on different subnets are able to
communicate.
5. Type the Deskset IP Address in the address bar, as shown in Figure 103,
and press ENTER. The browser displays the Login page as shown in
Figure 104 on page 92.
'HVNVHW,QIRUPDWLRQ
0RGHO1R6%
6WDWXV6\QFKURQL]HG
,3$GGUHVV
You can also use a Gateway IP address (shown in Figure 59 on page
69) to log in to the WebUI.