Installation guide

Getting Started 77
Synapse Installation Guide
ATA Configuration
Figure 68. ATA
Configuration
Press / in the ATA Main menu until Configuration is highlighted, as shown in
Figure 68, and press to display the Configuration menu. The current setting is
indicated with . You can use this interface or the WebUI to upgrade software.
Configuration — Current ATA settings:
 Auto IP — Is set automatically.
 Static IP — You can change the Static IP only from the ATA. See your network
administrator if you require details regarding IP assignments.
 Restore Defaults — Highlight Restore Defaults and press and hold for two
seconds when prompted to restore the ATA to factory defaults.
 Upgrade Software — Highlight Upgrade Software, and press . If new software
is available, you are prompted to press again to accept the upgrade.