Installation guide

Getting Started 74
Synapse Installation Guide
ATA Features
When the ATA is first connected to your LAN, the two FXS ports are configured as POTS phone lines and assigned the next
available extension numbers. ATA extension numbers do not appear in the Extension list on Deskset screens. They do, however,
appear on Call Logs, Redial lists, and Message lists. The two ATA extensions do not count toward the 100-extension limit of the
Synapse system.
Configure the interface to these analog devices through the WebUI. See “ATA Settings” on page 115.
In addition, one 10/100BT Ethernet port is provided for communication with the Synapse network. The front panel LCD and
buttons allow network configuration, firmware upgrades, and information functions. Figure 64 illustrates the ATA features and
connections.
Figure 64. ATA Features and Connections
1. Display Provides system and network status, device information, and configuration data.
2. Reset When pressed momentarily, restarts the ATA. When pressed and held for more than five
seconds and with the LAN cable not connected, restores factory defaults.
3. FXS 1, FXS 2 Station jacks for analog telephones, a fax machine, door phone, or overhead paging
equipment.
4. AUX IN Audio in for MoH.
5. AUX OUT Audio out, an option for OHP.
6. RJ-45 Ethernet Network Port 10Base-T/100Base-Tx with Auto MDI/MDI-X switching.
7. DC 12V Power-Supply Jack
1
2 3 4 5 6 7