Installation guide

Installation 58
Synapse Installation Guide
SB67040 Cordless Handset Installation
Charger Installation
Place the Handset in the charger when not in use.
 To plug the Handset charger into AC power:
Figure 44. Handset Charger Power Connect
1. Plug the power adapter into an electrical outlet not controlled by a
wall switch.
2. Plug the small end of the power adapter into the jack on the
underside of the charger.
3. Route the cord through the slot, as shown in Figure 44.
The SB67040 Cordless Handset requires registration to an SB67030/031 Deskset. The SB67020 Deskset does not support
the SB67040 Cordless Handset.
The SB67040 Cordless Handset is not supported when the system is in Line Appearance mode.