Installation guide

Installation 44
Synapse Installation Guide
[
 To connect the T1 Gateway T1 cable:
Plug the black T1 cable into the Gateway T1 Port, as shown in Figure 24, and into your T1/PRI network device from your service
provider.
Do not make any calls until the POWER and the SYN/ACT LEDs are green. See “T1 Gateway Features” on page 67.
Figure 24. T1 Gateway Line Connections
The SB67060 T1 Gateway must use only No.26 AWG or larger Telecommunications line cord to reduce the risk of
fire.
For customer service or product information, visit our website at www.telephones.att.com/smb or call
1 [phone]. In Canada dial 1 [phone].
T1 Port
T1 Status Indicators