Installation guide

System Configuration 140
Synapse Installation Guide
 To manually update a device to the latest software version: (Continued)
Figure 151. Upgrade Device Menu, Part 2
3. Click .
If there is an update available on the Internet, the
message shown in Figure 151 appears. Click
. The specified device restarts.
OR
In the Update Software From File section of the
page, enter a file name or click to select a
previously acquired upgrade file. Once selected, click
. The specified device restarts.
4. After the device restarts, check the software version
number at the device to confirm that the upgrade
was successful.
 On the Deskset: MENU –> Deskset
Information –> P Firmware Ver [030/031]
Software Ver [020].
 On the Gateway or ATA: Main Menu –> Device
Information –> Software.
If the device is sluggish or unresponsive during
the upgrade process, see “A Synapse device
becomes sluggish or unresponsive during or
immediately after software upgrade.” on
page 172.
As a device is updated, it restarts with the new
software version so it may disappear from the
device list if its software version is incompatible
with the device whose IP address was used for
logging into the WebUI.