Installation guide

System Configuration 124
Synapse Installation Guide
Single-Zone Overhead Paging Delay
When attached to an FXS port, single-zone overhead paging may require the Page tone to
be delayed. If this delay is too short, the beginning of the Page heard through the OHP
speakers may be cut off. You or the system installer need to experiment to find the correct
delay for the system. Set the delay in the WebUI. See “Overhead Paging Overview” on
page 22.
The delay starts after the user presses on the Deskset, as shown in Figure 132.
Once the delay ends, the page tone sounds and the Page screen appears, as shown in
Figure 133.
When OHP is enabled, the delay is used even if a single Overhead Paging zone
is not included in the page (i.e. even if there are only Desksets in the paging zone).
On the Deskset, the All Extensions option in the Paging Zones selection screen
includes the single Overhead Paging zone automatically.
Use or to scroll then press
SELECT or press digit.
Start
Paging Zones
Quick
Dial
1. All Extensions
2. Accounts
3. Design
4. Documentation
5. Management
6. Warehouse
Figure 132. Paging Zones
Including Single Overhead Zone
EndPage
Page
Press
EndPage
when done.
Paging Warehouse
Figure 133. Page to a Single
Overhead Zone