Installation guide

System Configuration 121
Synapse Installation Guide
Fax Settings
 To configure the fax settings:
Figure 129. Fax Configuration
1. In the Navigation Menu at left, click Fax
Configuration. The page shown in Figure 129
appears.
The current ATA FXS Port settings are shown.
2. Enable or Disable the fax. When disabled, the
incoming fax calls are directed like any other
incoming calls, but faxes cannot be received.
3. [PSTN] Select the Fax Mode: G.711 or T.38.
The Fax default setting is G.711. If the fax fails to
work in G.711 mode, change it to T.38.
4. Select the Fax Destination from the drop-down
list. This is the ATA FXS port to which the fax
machine is connected.
5. Select the Fax Line from the drop-down list. This is
the DID number or one of the PSTN Gateway
telephone lines to be used for fax communications.
6. Click to save these settings or click
to return to the previous page without saving the
changes.
T1 channels cannot be set as fax lines unless they have DID
numbers.