Installation guide

System Configuration 113
Synapse Installation Guide
 To configure the T1 settings: (Continued)
Figure 124. T1 Settings
8. Click to save any changes or click to
return to the previous page without saving the
changes.
9. Restart the T1 Gateway. Restarting the T1 Gateway
hangs up any active calls that are using the T1
Gateway.
 Press RESET on the T1 Gateway front panel for
less than 5 seconds.
OR
 Disconnect and reconnect T1 Gateway AC
power.
When you click , the T1 Gateway resets
itself. If there are Active Calls on the system,
the system waits until the last call ends and
the system is Idle. No new incoming or
outgoing calls can be made until the reset is
complete. During the reset, all LEDs on the
T1 Gateway front panel turn off for
approximately five to ten seconds. All Phone
Lines Busy appears on all Desksets
attempting to make a call.