Installation guide

Synapse Installation Guide Back to Contents

Getting Started 69

ATA Configuration

Press / in the ATA Main menu until Configuration is highlighted, as

shown in Figure 41, and press to display the Configuration menu. The current

setting is indicated with [*]. You can use this interface or the WebUI to upgrade

software.

Figure 41. ATA Configuration

Configuration — Current ATA settings:

 Auto IP — Is set automatically.

 Static IP — You can change the Static IP only from the ATA. See your network

administrator if you require details regarding IP assignments.

 Restore Defaults — Highlight Restore Defaults and press and hold

for two seconds when prompted to restore the ATA to factory defaults.

 Upgrade Software — Highlight Upgrade Software, and press . If new

software is available, you are prompted to press again to accept the

upgrade.

Upgrade ATA Software

If you have system settings that you want to retain, back up the settings before upgrading

the system software. You can also upgrade ATA software using the WebUI. See “Updating

Devices” on page 90.

To upgrade the ATA software to the latest version:

1. Press / in the ATA Main menu until Configuration is highlighted and

press to display the Configuration menu.

2. Press to highlight Upgrade Software and press to initiate the

software upgrade process. The device initiates a link to the Synapse software updates

web site host and any new software.

 If a host cannot be found or the server name cannot be resolved, Timeout or

Host Not Found appears. Upgrade the software from the PC, which can offer

more information about connection issues.

For more information, see the Synapse Administrator’s Guide at