Installation guide

AT&T SB67010/AT&T SB67030 Installation Guide 6 Deskset Installation
 To connect the RJ-45 Ethernet cable to the Deskset:
Figure 6. Network Connections
 With a PC connected to the network
1. Unplug the RJ-45 Ethernet cable from your computer.
2. Plug that RJ-45 Ethernet cable into the Network jack on the back
of the Deskset indicated in Figure 6.
3. Plug another RJ-45 Ethernet cable into the PC jack on the Deskset
indicated in Figure 6.
4. Plug the other end of that RJ-45 Ethernet cable into your
computer.
 Without a PC connected to the network:
Plug an RJ-45 Ethernet network cable into the Network jack on
the back of the Deskset, indicated in Figure 6, and plug the other
end into the Ethernet wall jack.
 To connect power:
Figure 7. Power Connector
1. Plug the power adapter into the DC Power jack on the back of the
Deskset, as indicated in Figure 7.
2. Plug the power adapter into an outlet not controlled by a wall
switch. The display screen illuminates within about a minute.
PC
Network
Power Jack
CAUTION: To help prevent the loss of system data during
power outages, plug the AC power plug into an
Uninterruptible Power Supply (UPS).