Installation guide

AT&T SB67010/AT&T SB67030 Installation Guide 5 Deskset Installation
Deskset Installation
Option 1 Option 2
Install the SB67030 Deskset on a desktop or mount it on a wall. The desktop setup
requires the Deskset Stand and provides two positions, Option 1 at 45° and Option 2
at 60°. If you use Option 2, rotate the Handset tab as explained in “To rotate the
Handset tab for wall and Deskset Option 2 installation:” on page 8.
 To attach the Deskset stand:
Figure 4. Deskset Stand Installation
1. Place the Deskset on a flat surface with the power and
network jacks facing you, as illustrated in Figure 4.
2. Locate the
flexible tab side,
illustrated in
Figure 5. Rotate
the stand so that
the flexible tabs
are away from
you.
3. Insert the solid
tabs into the
Option 1 or Option 2 slots on the base shown in Figure 4.
4. Rotate the stand away from you until it rests against the
base and you hear a click as it locks into place.
Option 1
Option 2
Jacks
Insert Flexible
Tabs Here
Insert Solid
Tabs Here
Figure 5. Deskset Stand Tabs
Flexible Tabs