Installation guide

AT&T SB67010/AT&T SB67030 Installation Guide 10 Gateway Installation
Gateway Installation
The system requires at least one Gateway for receiving or making external calls. You can place the Gateway on a table top or
mount it into a standard 19” metal rack. The Gateway must be installed within three feet of the building ground point. Install each
Gateway using the following instructions.
 To mount the Gateway into a standard 19” rack:
Figure 14. Rack-mount Bracket
Figure 15. Rack Installation
1. Remove the two Gateway mounting brackets and six screws from the
packing tissue.
2. Position the right bracket at the front of the chassis, as shown in Figure 14.
3. Place the bracket on the chassis so that the locating indent on the bracket
matches the indent on the chassis. This ensures that the screw holes are
aligned.
4. Insert each of the three screws
into the holes indicated in
Figure 16 and tighten securely.
Repeat the process for the left
bracket.
5. Position the Gateway into the
19” metal rack, as shown in
Figure 15.
6. Insert the top mounting screw
(not included) in one side and
turn it several turns to establish
support. Repeat for the other side.
7. Tighten the screws.
Mounting Bracket
Mounting
Screws
Locating Indent
Figure 16. Bracket Installed