Specifications

Syn248 Installation and Configuration Guide Back to Contents
Device Configuration 80
Fwd/Trans to Outside Line
You can enable or disable the ability of each Deskset to forward or transfer a call to an
outside line. These features use two of your telephone lines. This function is enabled by
default. Disabling this function prohibits the user from sending a call to an outside line
via the Gateway.
To enable or disable Forward/Transfer to an outside line:
1. On the Admin Settings menu, press 2 to display the Forward/Transfer to line
screen.
2. Press
 or  to select Enabled or Disabled.
3. Press to accept the changes and return to the Admin Settings menu.
IP Settings
On the IP Settings menu, you can manually configure the Deskset IP address. See
“Appendix B: IP Addresses and Connectivity” on page 104 for a discussion of the Syn248
network configuration and IP settings.
To display the IP Settings screen:
1. On the Admin Settings menu, press 3 to display the IP Settings screen.
2. Perform one of the following:
a. Press 1 to select IP Configuration. See “To set the IP Configuration:” on
page 81.
b. Press 2 to select Set/Edit Static IP. See “To set and edit static IP Address:” on
page 81.
c. Press 3 to select IP Status. See “To view the IP status:” on page 81.
Forw ard / Transfer
Fw d/Trans to Outside Line:
Enabled
Save
Save
If Intercom Call Forward–No Answer is set to Phone#, disabling
Fwd/Transfer to Outside Line causes a warning message to appear,
warning you that Call Forward–No Answer is set to OFF. You may want to
select a new target for the Intercom Call Forward–No Answer setting.
IP Settings
1. IP Configuration
2. Set/Edit Static IP
3. IP Status