Specifications

Features and Capabilities
Programming is accomplished
The PARTNER PagePac paging system can be installed with an AT&T
through your PARTNER system
PARTNER Pius or PARTNER II communications system. Listed below is
phone or a standard touch-tone
an overview of the basic features of the PARTNER PagePac paging
phone.
system along with some of the additional capabilities this module provides:
■
■
This port is also used to program ■
the PARTNER PagePac paging
system.
■
■
■
*If you use equipment that
■
rebroadcasts music or other
copyrighted materials, you may
be required to obtain a license
■
from a third party such as
ASCAP or BMI.
■
■
■
■
Primary Paging Zones (Zones 1 and 2) —Provides two independently
fully-programmable zones, each of which can be configured for speaker
output, door control, or an auxiliary amplifier. in addition, adjustment of
the two primary zones’ speaker volumes can be accomplished simply
from any PARTNER system phone or any standard touch-tone phone
on the PARTNER system.
Auxiliary Amplifier Zone (Zone 3) —provides a third, 0 dBm (600
ohms termination) output zone and a control closure suitable for
connection to a remote amplifier.
Telephone Access —Connects to a PARTNER station port, a
PARTNER CO port (see trunk adapter below), or PARTNER Page port.
Permits a user to page by dialing the telephone access port from a
PARTNER system phone or a standard touch-tone phone.
Remote Volume Adjustment —Permits the customer/installer to adjust
the volume of each primary zone by means of the keys on any
touch-tone telephone on the PARTNER system. This feature is
especially useful for speakers which are hard to reach, such as
high-ceiling locations (zones 1 and 2).
Microphone Attendant Access —Provides an interface input for
microphone access pages.
Night Bell —Connects to a PARTNER (station) port that has been
configured for night service. Generates tones over the paging system
when an incoming call is detected.
Music Input* —Connects to a music source. Music will be routed to all
specified zones when paging is not active.
Paging Amplifier —Provides a maximum of 4 watts of power for each
of the two primary paging zones. Supports voice coil (3.4 Vrms)
speakers only (zones 1 and 2).
Talkback —Allows specified paging speakers to be used as an
intercom (zones 1 and 2).
Door Control —Connects a paging zone up to two Doorspeakers.
Provides both Door Bell and Door Ajar inputs and a Door open output
(zones 1 and 2).
Trunk Adapter —Permits the user to conserve PARTNER station ports
by connecting the paging system to a PARTNER CO port through an
external Trunk Adapter.
Zone Overload Warning —Detects when one of the primary paging
zones is drawing too much power and automatically turns on a warning
light and temporarily suspends-output to the zone.
1-2 Overview