Specifications

Secondary Circuit Protection
B
Important Information
This equipment is for use on telephone wiring containing a secondary
circuit protector. This paging equipment requires a Harris Dracon model
22060-930 PageGuard
®
or AT&T IROB (PEC 60612) Secondary Circuit
Protector where applicable (see Figure B-1).
The secondary circuit protector must be located between the primary
protector and the paging equipment. Refer to the Important Safety
Information and Installation Steps below.
Important Safety Information
■
■
■
■
■
The PageGuard is used when connecting paging equipment directly to
telephone lines that may be exposed to high voltage power lines.
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
B-1 Secondary Circuit Protection