Specifications

ManualsBrandsAT&T ManualsCorded PhonesPagePac Plus AmpliCenter

Door Ajar

The Door Alert signal is triggered

by either a door bell or a door

ajar condition.

If you acknowledge the Door Ajar

condition, no further alert will

occur until the door is closed.

The Ring Down is triggered by

either a doorbell or a door ajar

condition.

Refer to Section 6 for

programming Doorspeaker Alert

Extensions.

Door Alert Mode:

If the Door Action option has been configured for Door Alert:

A door has been opened, but not closed within 30 seconds. A Door

Ajar is detected.

At each zone where Door Alert is enabled (Zone 1 or 2), you will hear

a high-low cadence, sounding once for Zone 1 (Door 1), and twice for

Zone 2 (Door 2). This tone repeats every five seconds for half a

minute, unless the user acknowledges the Door Ajar condition (or the

door is closed).

Dial into the system. (See step 1 of the Paging Procedure, page 7-2.)

If Door Ajar is in progress, you will hear a door ajar tone in the

telephone receiver (a constant rising and falling tone, or siren).

Acknowledge the Door Ajar condition by entering any touch-tone digit.

You will hear a door identification tone (one beep for Zone 1, two

beeps for Zone 2) before being connected to the speaker of the

active door.

If you hang up without acknowledging the Door Ajar condition, the

alert will be repeated after 30 seconds.

Ring Down Mode:

If the Door Action option has been configured for Ring Down:

A door has been opened, but not closed within 30 seconds. A Door

Ajar is detected.

The Doorspeaker Alert Extensions that have been programmed on

the PARTNER switch will ring.

Pick up the ringing extension to answer the door.