Specifications

3. Speak into the telephone transmitter to make your page.
During a page, you can dial [#] to go back to the PARTNER
PagePac dial tone; dial another zone number or zone group number
to switch to that zone or zone group.
4. Hang up the telephone.
Paging Options
Pre-Announcement Tone:
If Pre-Announcement Tone is configured, it will be issued before a page to
all speakers in the selected zone or group.
Talkback Mode:
NOTE: Talkback Mode works
1.
only for a single-zone page.
2.
3.
Follow steps 1 and 2 of the Paging Procedure, above.
In your telephone receiver, you can monitor conversation from the
zone enabled for Talkback Mode.
Speak into the telephone transmitter to page, or listen to someone
speaking at the zone. (One person can speak at a time; the person
speaking into the telephone will take precedence over the person
speaking at the zone.)
Hang up the telephone.
If Talkback Warning Tone is enabled, a tone will be sent to the zone
enabled for talkback, to advise anyone within range of the zone that
conversation is being monitored. This tone is also sent to your
telephone receiver.
Microphone Page Enabled:
By default Doorspeaker does not
1. Turn the switch on the microphone to ON.
receive a microphone page.
2. Speak into the microphone to make your page.
Your page will be heard at any zone where Microphone Page is
enabled.
3. Turn the microphone switch to OFF.
Night Bell Enabled:
Refer to Night Bell Programming
When Night Service is enabled by the button on the system phone at
in Section 6.
extension 10:
1. An outside call comes in.
All system phones selected in the Night Service Group will ring.
Ringing will be heard at all zones where Night Bell is enabled.
2. Pick up any telephone on the line that is configured for Night Bell to
connect to the incoming call.
Night Bell will stop ringing over the paging system.
.
Operating Procedures 7-3